Event Inspector

The Event Inspector module is available in the Control Bar. The Event Inspector has the following:

Time

Pitch

Velocity

Duration

Channel

Figure 376. The Event Inspector module.

A. Time B. Duration C. Pitch D. Velocity E. Channel

To display a note’s properties in the Event Inspector

Select a note.

If you select multiple notes, the Event Inspector displays the note value if all selected note values are the same. If the note values are different, the Event Inspector does not display anything.

To change a note’s properties using the Event Inspector

1.	Select a note.

2.	In the appropriate Event Inspector field, change the value. See the following table for a description of valid value entries for each field in the Event Inspector.

Event Inspector Field	Valid Values
Time	Any valid M:B:T time value. Separate values with a colon or a space. For example, measure 2, Beat 3, Tick 720 would be written as 2:3:720.
Pitch	Note names (C0 through G10) and note numbers (0 through 127) are valid in this field. Also, you can use a modifier to raise or lower the value by a number of half-steps. To raise the pitch by 2 half-steps, type +2 and press ENTER. To lower the pitch by 2 half-steps, type -2 and press ENTER.
Velocity	A velocity value or modifier value are valid in this field. Valid velocity values are 0 through 127. Valid modifier values are +/- 0 through 127.
Duration	A PPQ value.
Channel	1 through 16.